Skip to main content

SYNERGYF4

Specifications​

  • Processor: STM32F405 (F4 processor)
  • Gyro: MPU6000
  • Loop: 8k/8k
  • Input: 2-6S (Max 28V)
  • Regulator: Filtered 5V 3A
  • Receiver: 3.3V or 5V selectable. Inverted and non-inverted selectable receiver input
  • Connectors: 8 pin JST-SH main connector. 2x 3 pin JST-SH Addressable LED connectors (mirrored output)
  • Telemetry: Current Sensor and ESC Telemetry Input
  • Blackbox: 128Mbit flash (16Megabytes)
  • Motor: 4 pwm motor outputs with DShot and Multishot support
  • Mounting: M3 30.5x30.5mm holes with soft mounting
  • Dimensions: 37x37mm
  • Weight: 7.5g
  • Camera: Filtered 5V output

Features​

  • Direct mounting for Unify Pro (5V), Unify Nano, Unify Pro Nano32 (Nano VTXs use adapter board included)
  • Direct mounting for TBS CrossFire Nano RX, TBS CrossFire Nano Diversity RX, FR Sky XM+, and FR Sky R9m Mini (R9m Mini Adapter Included From Tiny's LEDs)
  • Header holes for direct receiver installation.
  • Built in camera control via single wire (analog only)
  • Built in BetaFlight OSD
  • Buzzer: Dedicated pads for 5V (100mA max) buzzers
  • Onboard addressable LED
  • Built in Tiny’s LEDs RealPit VTX power switch (selectable between ON-OFF-Remote)
  • Receiver can be powered on via USB (VTX stays off)
  • SmartAudio: Selectable between internal (FC controlled) and external (receiver).

UART info​

  • UART1: Receiver (FrSky, Spektrum, Crossfire, etc)
  • UART3: SmartAudio (or any other desired output if SmartAudio is selected to pull signal from the “external” pad, designated RX SA on the top of the FC)
  • UART6: ESC Telemetry (if applicable).

Top​

Top

Bottom​

Bottom

Photo​

Main

*** The flight controller does not include a receiver or VTX. The picture is for illustration only!

Installation​

Where to get​